Designing Heat Exchangers for Additive Manufacturing
Our Metal DfAM eSeries kicks off week 2 with a focus on Heat Exchangers. A majority of the focus on Triply Periodic Minimal Surfaces (TMPS) and their applicability.
In our day to day lives, we are surrounded by devices used to make our daily routines or spur of the moment decisions more enjoyable, productive, and fulfilling. The devices that enable all of that to happen usually come in the form of electrical or mechanical systems, all of which produce heat. That heat (or temperature) needs to be regulated & directed away from the critical components of those deceives so that they continue to function properly.
There are a multitude of methods used to remove unwanted heat from a system. In our Design for Additive Manufacturing (DfAM) eSeries for Metal Processes we are dedicating a week to heat exchangers. We will briefly go over some of the past and current state of heat exchanger applications with regards to traditional designs & techniques. As well as where some of the industry is at, as a whole, in regards to advanced design methodologies and manufacturing.
The majority of the focus will be on Triply Periodic Minimal Surfaces (TMPS) & their applicability to heat exchangers. Topics covered will be their effectiveness, control of design parameters, printability, validation, characterization of parameters that impact system-level or unit performance, real-time simulation, and the ability to capture design intent at the start of the design process.
Each design covered will show how we built on or worked in parallel with targeting different industries and aspects of the applicability of design, performance, manufacturing & validation of these complex structures.
Check out our webinar
For more information on this topic, check out our corresponding webinar by clicking the link below.